FC2822 1220KV Internal resistance seems a touch high...

[Markus]

The internal resistance of the FC2822 motor seems a little high... the listing has it as 150 Ohms - shouldn't that be 0.150 Ohms?

[Phil_G]

No, its quite right at 150 ohms.
Theres a mistake in the voltage rating however, it should be 600 - 1200 volts, rather than 6-12 as listed.



Phil





PS Joke...

[Markus]

0.150 Ohm it is. Thanks.

(Hey, I've never bought a brushless motor before, what do I know? )

[Phil_G]

Sorry, couldnt resist
Its a nice motor, I bought a couple a while ago. One came with a bent shaft (think posty had dropped it) but its easy to swap shafts.
Its a bit like an electric 1cc diesel or an electric .049 glow. Someone in our club has a twinstar with a couple, flies ok.
Cheers
Phil

[DH106]

Yes, I'll second that
I've used these as outrunner replacements for the stock brushed motors on a couple of the GWS fighters - Spitfire, Mustang etc.
Very effective, good power & light weight.